Overview
This aftermarket 10-inch replacement chain is designed to fit select Worx chainsaw models. It replaces the factory chain when the original becomes dull beyond resharpening, damaged, or stretched past the tensioner’s range. Keeping a spare chain on hand means less downtime during cutting season — swap in a fresh chain and keep working while you sharpen the old one on the bench.
Key specifications
- Bar length: 10”
- Pitch: 3/8
- Type: Semi-chisel (aftermarket replacement)
Compatibility
Engineered to match the specifications of select Worx chainsaw models, this chain drops in without modification. Before ordering, verify the three critical numbers — pitch, gauge, and drive-link count — against the stamp on your guide bar. A mismatch in any one dimension means the chain won’t fit safely.
Installation notes
Power down the saw and remove the battery or disconnect it from power before servicing. Remove the side cover or bar-cover plate to expose the bar and sprocket. Slide the worn chain off the bar groove and sprocket, noting the direction of the cutters. Install the new chain with cutting teeth facing forward on top of the bar. Reattach the cover and adjust chain tension — the chain should pull slightly away from the bar rail and snap back without sagging.
Common questions
Q: Will this Morocca 2PC 10” chainsaw chain fit my Worx WG323.9, or is it only for the WG322 models?
Yes, this chain is listed as compatible with both the Worx WG322/WG322.9 and WG323/WG323.9 10-inch cordless saws. As long as your saw uses a 10” bar with a 3/8 pitch chain in the 40-043” spec range, this replacement should fit properly.
Q: I have a Worx WG322 with a 10-inch bar—do I need to do anything special when installing this new chain?
Make sure the chain is routed in the correct cutting direction before tightening the bar cover, since installing it backwards is a common mistake. After installation, set the chain tension so it sits snug on the bar but still pulls around by hand, then recheck tension after the first few minutes of use because new chains can stretch slightly.
Q: How often should I sharpen or replace this 10” Morocca chain on my Worx cordless saw?
Sharpen it when you notice it making fine dust instead of chips, pulling to one side, or requiring extra pressure to cut. Keep the chain properly tensioned and the bar oiled, and replace it if the cutters are worn down significantly or the chain has damaged or cracked links.
