Overview
This aftermarket 16-inch replacement chain is designed to fit select Black & Decker chainsaw models. It serves as a drop-in replacement when the original chain becomes dull past the point of resharpening, develops a damaged cutter, or has stretched beyond the tensioner’s adjustment range. Having a spare on the shelf eliminates trips to the dealer mid-project.
Key specifications
- Bar length: 16”
- Type: Semi-chisel (aftermarket replacement)
Compatibility
This chain is manufactured as a direct-fit replacement for select Black & Decker chainsaws listed in the compatibility section above. Always cross-check the pitch, gauge, and drive-link count stamped on your current bar before ordering — even within the same brand, different models can require different chain specs.
Installation notes
Start by removing the battery or disconnecting the power cord. Take off the bar-cover plate and release bar tension. Pull the old chain out of the groove and off the sprocket. Seat the replacement chain into the bar groove — cutters must face forward on the top of the bar. Engage the chain on the drive sprocket, reinstall the cover, and adjust tension so the chain lifts about a dime’s width off the bar and springs back. Hand-rotate the chain to check for binding before powering on.
Common questions
Q: Will the 5140162-93 16” replacement saw chain fit my Black & Decker CS1216 12 Amp 16 in. electric chainsaw?
Yes, this chain is made to fit the Black & Decker CS1216 with the 16-inch bar. If your saw is the CS1216 and still uses the original 16-inch bar setup, this is the correct replacement chain for that model.
Q: Do I need any special tools to install the 5140162-93 chain on a CS1216, and how do I know it’s on correctly?
You typically only need the saw’s bar cover hardware loosened so you can remove the side cover, seat the chain around the sprocket, and place it along the bar groove. Make sure the cutting teeth on the top of the bar face forward, then adjust the tension so the chain sits snugly but can still be pulled around the bar by hand with gloves.
Q: How should I maintain this 16” saw chain to keep it cutting well on my Black & Decker CS1216?
Keep the chain properly tensioned and make sure the saw’s bar-and-chain oil reservoir is filled before use, since a dry chain will wear quickly and cut poorly. It also helps to clean the bar groove and check for dull cutters regularly, especially if the chain has contacted dirt or wood with embedded debris.
