Overview
This 3-pack of aftermarket 14-inch replacement chains is designed to fit select Kobalt chainsaw models. Over time every chain stretches, dulls, and eventually needs replacing. This aftermarket option matches the OEM pitch, gauge, and drive-link count so you can install it directly without modifications. A fresh chain also reduces strain on the bar and sprocket.
Key specifications
- Bar length: 14”
- Quantity: 3-pack
- Type: Semi-chisel (aftermarket replacement)
Compatibility
Engineered to match the specifications of select Kobalt chainsaw models, this chain drops in without modification. Before ordering, verify the three critical numbers — pitch, gauge, and drive-link count — against the stamp on your guide bar. A mismatch in any one dimension means the chain won’t fit safely.
Installation notes
Disconnect power before any chain work. Remove the bar cover to access the sprocket and bar. Take note of the cutter direction, then remove the old chain. Place the new chain in the bar groove with cutters oriented forward on the top rail. Loop it onto the drive sprocket, replace the cover, and turn the tension adjuster until the chain sits snug with minimal sag. Spin the chain by hand to confirm it moves freely.
Common questions
Q: Will this 3-pack 14” 52 link chain fit my Kobalt KCS 1040B-03 40V chainsaw, or is it only for the KCS 4040-06?
Yes, this chain is made to fit the Kobalt KCS 1040B-03, KCS 1040A-03, and KCS 4040-06 as long as your saw uses a 14-inch bar and the CL14352PB chain spec. Since this is a 52-drive-link replacement chain, it’s important to match both the bar length and chain spec rather than going by brand alone.
Q: My original chain is marked CL14352PB—does this replacement match that exactly, and do I need to change the bar too?
If your current chain is CL14352PB and you’re running the factory 14-inch bar on the listed Kobalt models, this replacement is the correct match. You do not need to replace the bar unless it is badly worn, bent, or the groove is damaged from prior chain wear.
Q: What’s the best way to install and maintain these 52 link chains on a Kobalt KCS 4040-06 so they don’t stretch too fast?
When installing, make sure the cutters face forward on the top side of the bar, then tension the chain so it sits snugly but still pulls around by hand with gloves on. For longer chain life, keep bar oil topped off, recheck tension after the first few cuts, and touch up the cutters regularly since a dull chain heats up and stretches faster.
