Saw Chains · SKU B0D6YJJ7NC

2PC 14" Replacement Chainsaw Chain

Name: 2PC 14" Replacement Chainsaw Chain
Brand: MOROCCA
SKU: B0D6YJJ7NC

$14 Amazon rating ★ 4.1

2PC 14" Replacement Chainsaw Chain For Kobalt KCS 4040-06 40-Volt Chainsaw 40-Volt 14-in Brushless Cordless Electric Chainsaw

Bar length14"

Pitch3/8" LP

Gauge.043"

Drive links52DL

Same size fits372 saw models →

CategorySaw Chains

Part numberB0D6YJJ7NC

ConditionNew — aftermarket replacement

What the listing states

Listed as compatible with: Kobalt KCS 4040-06, KCS 1040A-03, KCS 1040B-03
Chain type: Semi-Chisel
Pieces in pack: 2

From our Amazon listing, checked September 25, 2026. Model and part-number matches are the seller's; confirm against the part on your machine.

Before you buy — how to verify fitment

Find the bar stamp. Look on the side of your current guide bar for the pitch, gauge, and drive-link count.
Match all three numbers. Pitch (3/8 LP), gauge (.043"), and drive links (52DL) must all match.
Check bar length. Measure cutting length from the tip to where the bar enters the saw body — this should match 14".
Confirm your saw model against the compatibility list above. If your model isn't listed, the chain may still fit if pitch/gauge/DL match.

Frequently asked questions

How do I know this chain fits my saw?

Match three numbers: pitch, gauge, and drive-link count. All three must match the stamp on your current bar. If even one is off, the chain won't fit safely.

How do I measure pitch and gauge?

Pitch is the distance between any three consecutive rivets, divided by two. Gauge is the thickness of the drive links — measure with a caliper or check the bar stamp. Our guide covers both in detail.

How long does a replacement chain last?

With proper tension and occasional sharpening, an aftermarket chain lasts 3–5 cords of firewood or about 5 hours of active cutting — roughly the same as OEM.

Can I sharpen this chain or is it single-use?

Absolutely sharpen it. A quality replacement chain can be sharpened 3–5 times before the cutters are too short. Keep a round file matched to the cutter diameter.